NEXCOM NDiS B532 - Manual (Page 67)

Copyright © 2013 NEXCOM International Co., Ltd. All Rights Reserved. 53 NDiS B532 User Manual
Chapter 4: BIOS Setup
Security
Advanced Boot Security Save & Exit Main
Version 2.15.1234. Copyright (C) 2012 American Megatrends, Inc.
Aptio Setup Utility - Copyright (C) 2012 American Megatrends, Inc.
→←: Select Screen
↑↓: Select Item
Enter: Select
+/-: Change Opt.
F1: General Help
F2: Previous Values
F3: Optimized Defaults
F4: Save & Exit
ESC: Exit
Set Administrator Password Password Description
If ONLY the Administrator’s password is set,
then this only limits access to Setup and is
only asked for when entering Setup.
If ONLY the User’s password is set, then this
is a power on password and must be entered to
boot or enter Setup. In Setup the User Will
have Administrator rights.
The password length must be
in the following range:
Minimum length 3
Maximum length 20
Administrator Password
User Password
HDD Security Configuration:
HDD0:ST320LT012-9
Administrator Password
Select this to reconfigure the administrator’s password.
User Password
Select this to reconfigure the user’s password.
HDD Security Configuration
Select this to configure the HDD security password.
Save & Exit Advanced Boot Security Save & Exit Main
Version 2.15.1234. Copyright (C) 2012 American Megatrends, Inc.
Aptio Setup Utility - Copyright (C) 2012 American Megatrends, Inc.
→←: Select Screen
↑↓: Select Item
Enter: Select
+/-: Change Opt.
F1: General Help
F2: Previous Values
F3: Optimized Defaults
F4: Save & Exit
ESC: Exit
Reset the system after
saving the changes.
Save Changes and Exit
Discard Changes and Exit
Restore Defaults
Save & Exit
Save Changes and Exit
To save the changes and exit the Setup utility, select this field then press
. A dialog box will appear. Confirm by selecting Yes. You can also
press to save and exit Setup.
Discard Changes and Exit
To exit the Setup utility without saving the changes, select this field then
press . You may be prompted to confirm again before exiting. You
can also press to exit without saving the changes.
Restore Defaults
To restore the BIOS to default settings, select this field then press . A
dialog box will appear. Confirm by selecting Yes.