Apm configuration – NEXCOM NDiS B322 User Manual
Page 39
Copyright © 2012 NEXCOM International Co., Ltd. All Rights Reserved.
26
Chapter 4: BIOS Setup
NDiS B322 User Manual
Exit
Advanced
Power
Security
Boot
Main
v02.61 (C)Copyright 1985-2010, American Megatrends, Inc.
BIOS SETUP UTILITY
APM Configuration
← →
Select Screen
↑↓
Select Item
+-
Change Option
F1
General Help
F10 Save and Exit
ESC Exit
Power Settings
ACPI Configuration
APM Configuration
EUP
The wake up funciton be
lost if EUP is enabled.
Power on PME#
Enables the system to wake up to respond to PCI card such as LAN card
or modem card that uses the PCI PME (Power Management Event) signal
to remotely wake up the system. Access to the LAN card or PCI card will
cause the system to wake up.
AC Power Loss
Power Off
When power returns after an AC power failure, the system’s power is off.
You must press the Power button to power-on the system.
Power On
When power returns after an AC power failure, the system will automati-
cally power-on.
Last State
When power returns after an AC power failure, the system will return to
the state where you left off before power failure occurs. If the system’s
power is off when AC power failure occurs, it will remain off when power
returns. If the system’s power is on when AC power failure occurs, the
system will power-on when power returns.
EUP
Enables the system to shut down to the lowest possible power state by
removing all power to the system board. The wake up function will be lost
if EUP is enabled.
[Disabled]