Installing a sata hard drive – NEXCOM NISE 3500 User Manual
Page 54
Copyright © 2011 NEXCOM International Co., Ltd. All Rights Reserved.
41
NISE 3500, NISE 3500M User Manual
Installing a SATA Hard Drive
1. With the bottom side of the chassis facing up, remove the screws of
the bottom cover.
2. Remove the 4 mounting screws that secure the drive bay to the chassis.
If you are installing one SATA drive only, the system will allow you
to install an optional CompactFlash card, a half length SATA DOM
or a full length SATA DOM.
3. Remove the drive bay. The drive bay is used to hold a SATA hard drive.
This manual is related to the following products: