Neotech Communications GEC-48CHP-R - Manual (Page 3)

GEC-48CHP-R / GEC-416CHP-R
Receiver of 8/16-port Ethernet Extender over Coax with PoC + 4-port 10/100/1000TX Ethernet Switch
3 V1.0
Installation
GEC-48CHP-R/GEC-416CHP-R can be installed on a 19” rack cabinet. The product has 4 mounting holes. Use 4
rack mount screws to securely install the product in the rack cabinet.
Setup
1. The GEC-48CHP-R/GEC-416CHP-R is a plug-and-play device. Connect the socket of AC power cord to the AC
inlet of the receiver and plug the other end into a standard AC outtlet. Turn on the switch, the PWR LED will
then be lit.
2. The READY LED will be lit (ON) when the receiver is ready for data transfer.
3. Connect one end of the coaxial cable to the female BNC connector (COAX DATA) of
GEC-48CHP-R/GEC-416CHP-R and the other end to the transmitter (FEC-11CHP). If the transmitter and
receiver are properly connected and communicated with each other, the ACT will be lit (ON). The PoC LED will
be lit too when the PoC is in use.
4. Connect the Ethernet cable from the NVR or PC or similar equipment to the Ethernet port (10/100/1000M). If
the cable is properly connected, the corresponding LED (100M or 1000M depend on the Ethernet connection)
at the RJ45 port with be lit. If there is data being transferred, the LED will be blinking.
Interface
RJ-45 Pin Assignment
Pin Signal Name
1 TP0+
2 TP0-
3 TP1+
4 TP2+
5 TP2-
6 TP1-
7 TP3+
8 TP3-
Power Connection
The power interface of GEC-48CHP-R/GEC-416CHP-R complies with the IEC60320-C14 standard and the AC
power socket complies with the IEC60320-C13 standard
Mounting
Holes