Neotech Communications FEC-11CP - Manual (Page 2)

FEC-11CP Series
Industrial 10/100Base-TX Ethernet over Coaxial Converter with PoE & PoC
2 V1.3
Connecting to Power
The EoC converter is a plug-and-play device. The TX and RX supports two type of power supply.
Receiver (RX)
1. External Power Adapter - Connect the supplied AC to DC power adaptor to the receptacle on the rear panel of
the receiver, and then attach the plug into a standard AC outlet. The PWR LED will then be lit.
2. Power over Ethernet (PoE) - Connect the Ethernet cable from an Ethernet switch with PoE to the RJ45 of the
receiver, the PWR LED will then be lit. In this case, power adapter is not needed.
Transmitter (TX)
1. External Power Adapter - Connect the supplied AC to DC power adaptor to the receptacle on the rear panel of
the transmitter, and then attach the plug into a standard AC outlet. The PWR LED will then be lit.
2. Power over Coax (PoC) - When the coaxial cable is properly connected between the transmitter and receiver,
the transmitter can get the power from the remote receiver through the coaxial cable. The PWR LED will then be
lit. In this case, power adapter is not needed.
.
Connecting to Coax
Connect the coaxial cable to the BNC socket of the transmitter and receiver. If the transmitter and receiver are
properly connected and communicated with each other, the Link LED of the transmitter and receiver will be lit (ON).
The PoC LED of the receiver will be lit too.
Connecting to Ethernet
Connect the Ethernet cable from the IP camera to the RJ45 port of the transmitter. If the cable is properly connected,
the Act LED of the Ethernet port of the transmitter will start flashing. When the connected camera is a PoE IP
camera, the transmitter will supply power to the camera through the Ethernet port and the PoE LED will be lit.
Connect the Ethernet cable from the NVR or an Ethernet switch or similar equipment to the RJ45 port of the receiver.
If the cable is properly connected, the Act LED of the Ethernet port of the receiver will be lit.
The 10/100Base-TX Connector
The 10/100Base-TX Connections
The following lists the pinouts of 10/100Base-TX ports.
Pin Regular Ports PoE
1 Output Transmit Data + Unused
2 Output Transmit Data - Unused
3 Input Receive Data + Unused
4 Unused Positive (VCC+)
5 Unused Positive (VCC+)
6 Input Receive Data - Unused
7 Unused Negative (VCC-)
8 Unused Negative (VCC-)
The transmitter, as a Power Sourcing Equipment (PSE), use the data wires (alternative A) to supply power to the IP camera
( Power Device (PD)).