KBC Networks WESII 11/17dBi Point-to-Point Host - Manual (Page 4)

Default Configurations
Parameter Setting
LAN IP Address 192.168.1.200 (Host/AP) 192.168.1.201 (Client)
GUI User ID admin
GUI Password admin
SSID KBC-WESII
Pre-shared Key 11111111
Frequency selection (Host
only) Auto
Bandwidth 20/40
Long Range Parameters Enabled
Note: A restore to defaults will erase custom configuration settings and disable the MAC lock feature.
WESII Status Indicators
1. Signal Strength Indicator – 40 RSSI
2. Signal Strength Indicator – 30 RSSI
3. Signal Strength Indicator – 20 RSSI
4. Signal Strength Indicator – 10 RSSI
5. Ethernet Link Activity
6. Power
Compliance
FCC
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s
authority to operate the equipment. This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions:
• This device may not cause harmful interference, and
• This device must accept any interference received, including interference that may cause undesired
operation.
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to
part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference when the equipment is operated in a commercial environment. This equipment generates, uses,
and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual,
may cause harmful interference to radio communications. Operations of this equipment in a residential area is
likely to cause harmful interference in which case the user will be required to correct the interference at his own
expense.
Industry Canada
This Class A digital apparatus complies with Canadian ICES-003. To reduce potential radio interference to other
users, the antenna type and its gain should be so chosen that the equivalent isotropically radiated power
(E.I.R.P.) is not more than that permitted for successful communication. This device complies with Industry
Canada license-exempt RSS standard(s).
Operation is subject to the following two conditions:
• This device may not cause interference, and
• This device must accept any interference, including interference that may cause undesired operation of
the device.
Cet appareil numérique de la classe A est confrome à la norme NMB-003 Canada. Pour réduire le risque
d’interférence aux autres utilisateurs, le type d’antenne et son gain doivent être choisies de façon que la
puissance isotrope rayonnée équivalente (PIRE) ne dépasse pas ce qui est nécessaire
1 2 3 4 5 6