KBC Networks WESII 11/17dBi Point-to-Point Host - Manual (Page 3)

7. Select: ‘Basic Wireless’ and choose your country – not required for units purchased in the US.
Select:
Select:
Note: It is the user’s responsibility to ensure that the correct country is chosen. KBC accepts no liability for
incorrectly set up equipment.
8. Select: to determine which frequencies are available in your location.
Select: one of the available channels.
Select:
Select:
Note: The Client will not need the frequency selection but will need the country setting, SSID and the channel
spectrum width to be the same as the Host.
9. Note down all the MAC addresses and SSIDs used in the application for future reference.
Note:
Point to point Host/Aps and their respective Clients must be MAC locked to one another.
Configuring the Mapping Option
If you have chosen the mapping option on your WESII unit you will
be able to view the system configuration and health all on one
page. Mapping is purchased as a separate option; please contact
KBC Networks if you would like to add this to your unit.
Note: only KBC nodes are shown on the topology page.
1. In the web browser
Select:
‘Basic Network’
Enter : enter a gateway address
Note: the gateway address must be a ping-able network device that is connected to any one of the system
node’s Ethernet port.
2. Once the complete system has been configured and is properly connected, a generic map will be created
in the Topology page.
Note: the router symbol is used to represent the gateway. All nodes will have the same gateway IP address
which is set to the gateway shown connected to Node 1.
3. In the Topology page to upload a background image
Select:
4. Choose a file
Select:
Note: The image size is limited to 120kB and must be JPEG or GIF format.
5. Move the nodes around on the page to represent their physical locations.
Select:
6. Hover over the node to display details of the radio link.