Junger Audio b44 - SDI Audio Converter/Router - Manual (Page 9)

3. INSTALLATION
INSTALLATION
3.1
UNPACK THE UNIT
3.2
POWER SUPPLY
3
The SDI converter/router b44 was carefully packed in the factory and
the packaging was designed to protect the equipment from rough
handling. Please examine carefully the packaging and its contents for
any signs of physical damage, which may have occured in transit.
The SDI converter/router b44 is a device under the safety category
Schutzklasse 1 in keeping with the VDE 0804 standards and may only
used with power supply installations built according to regulations.
Check the voltage details printed at the rear panel are the same as
your local mains electricity supply.
The SDI converter/router b44 is equipped with standard connectors
(see also chapter 3).
Before connecting the SDI converter/router b44 switch the power off at
all connected units
.
The SDI converter/router b44 is made as standard 19“ unit (EIA
format). It occupies 1 RU (44 mm height) space in a rack.
Please allow at least addititonal 3“ depth for the connectors on the rear
panel.
When installing the unit in a 19“ rack the rear side of the unit needs
some support, especially for mounting in flight cases.
The SDI converter/router b44 should not be installed near units which
produce strong magnetic fields or extreme heat. Do not install the filter
processor directly above or below power amplifiers.
If, during operation, the sound is interrupted or displays no longer
illuminate, or if abnormal odor or smoke is detected immediately
disconnect the power cord plug and contact your dealer or Jünger
Audio.
The SDI converter/router b44 has a digital signal outputs. To the
problem-free combination of following digital devices, the digital signal
processing can be locked to an external clock reference. The selection
of the corresponding input is made with the SYNC switch in the MODE
section. If the chosen sync input is connected with the sync signal, this
signal is used for synchronization automatically. Otherwise the unit is
locking to internal 48 kHz. The digital output signal can be clocked with
the following clock frequencies:
3.3
CONNECTIONS
3.4
RACK MOUNTING
3.5
OPERATION
SAFETY
3.6
SYNCHRONIZATION
OF
DIGITAL OUTPUT
Operation manual b44, chapter 3 -installation- page 3-1