Junger Audio b44 - SDI Audio Converter/Router - Manual (Page 14)

4. LOCATION OF PARTS AND CONTROLS
fig. 2: rear panel b44
4.2.
REAR PANEL
TALLY
DIGITAL
IN/OUT
GPI
SYNC
IN/OUT
ANALOG IN
ANALOG OUT
SDI
IN/OUT
SERIAL
REMOTE
SERIAL
CAN
ADDR
SWITCH
POWER INPUT
IEC mains input connector 85-265 V, 50 - 60 Hz with integrated fuse
REMOTE
serial remote interface RS-232
connector: 9pin SUB-D, female
serial remote interface CAN
connector: 9pin SUB-D, male
ADDR - for selection of unit address
GPI
parallel remote interface input, TTL-level
connector: 15pin SUB-D, female
TALLY
parallel remote interface output, TTL-level
connector: 15pin SUB-D, female
SYNC
IN input for ext. sync signal (AES/WCLK/VIDEO, unbal)
connector: BNC socket
WCLK OUT output for WCLK
connector: BNC socket
SDI IN / OUT
Input/output for serial digital video (ITU-R BT.601, SMPTE 272M-A)
Format: Video: 270 Mb/s, 525/625 line rate, 75 Ohm,
BNC socket
AES IN/OUT
input for AES/EBU standard format
connector: BNC socket 75 Ohm, unbalanced
output for AES/EBU standard format
connector: BNC socket 75 Ohm, unbalanced, 0.5V pp
ANALOG IN/OUT
Analog input to 24 bit A/D-converter
Input electronically balanced, XLR connector female
Analog output from 24 bit D/A-converter
Output electronically balanced, XLR connector male
page 4-2 Operation manual b44, chapter 4 -control elements and displays-