ILUMINARC Ilumipod™ 7 IP - Manual (Page 15)

Operation
Ilumipod 7 IP Optic RGBW User Manual (Rev. 4) 11
4. Operation
When you scroll
through the
menu options,
you will see
many of them that do not
correspond with the menu
map. Skip them, as they
do not work with the
RGBW only output
products.
Ilumicode
The Ilumipod 7 IP Optic RGBW needs an external controller, the Ilumicode addresser, to
change its configuration.
Ilumicode Panel Description
Control Options
You can set the Ilumipod 7 IP Optic RGBW start address in the 001~512 DMX range. This
allows for the control of up to 73 products in the 10-channel ARC FULL personality.
Programming
Carry out all the programming procedures indicated below from the control panel. Refer to the
Menu Map in page 13 to learn how the menu options relate to each other.
Use and
DMX Personality
1. Go to PERS and select any DMX personality.
2. Make sure to rearrange the DMX addresses of all products in the current DMX
universe to avoid address overlapping.
DMX Starting Address
1. Go to DMX.
2. Select a starting DMX address (001~512).
Button Function
Enables the currently displayed menu or sets the
currently selected value into the selected function
Navigates upwards through the menu list and increases
the numeric value when in a function
Navigates downwards through the menu list and
decreases the numeric value when in a function
Turns the unit on. The unit will turn off automatically
after 30 seconds of inactivity.