ILUMINARC Ilumipod™ 7 IP - Manual (Page 10)

Operation
6 Ilumipod 7 IP Optic RGBW User Manual (Rev. 4)
3. Installation
Always connect
the Ilumipod 7 IP
Optic RGBW to a
protected circuit with an
appropriate electrical
ground to avoid the risk of
electrocution or fire.
Never connect
the Ilumipod 7 IP
Optic RGBW to a
rheostat (variable resistor)
or dimmer circuit, even if
the rheostat or dimmer
channel serves only as a
0 to 100% switch.
Make sure to
connect the
Ilumipod 7 IP
Optic RGBW to a power
line with the proper
voltage and frequency, as
per the specifications in
this manual or on the
product’s sticker.
AC Power
The Ilumipod 7 IP Optic RGBW has an auto-ranging power supply that can work with an input
voltage range of 100~240 VAC, 50/60 Hz.
Make sure that you are connecting this product to the proper voltage, as per the specifications in
this guide or on the product’s sticker.
Power Consumption
To determine the power requirements for the Ilumipod 7 IP Optic RGBW see the label
affixed to the side of the product. Alternatively, you may refer to the specifications
chart in the Technical Information chapter of this manual.
The listed current rating indicates the maximum current draw during normal operation.
AC Plug
The Ilumipod 7 IP Optic RGBW comes with an un-terminated power input cord for
hardwiring during installation. Use the table and the illustration below to wire a plug.
Connection Wire (US) Screw Color (US) Wire (Europe) IP67 Pin
AC Live Black Yellow or Brass Brown 1
AC Neutral White Silver or Gray Blue 2
AC Ground Green/Yellow Green Green/Yellow 3
The listed
current rating
indicates the
maximum
current draw during
normal operation.
If you choose to
bury the power or
signal distribution
boxes, make sure that
they are IP67 rated or
greater.
Power Wiring
You can connect the bare-ended IP67 rated AC power cable from the product to an
IP67 rated power connector or IP67 rated junction box.
If using junction boxes, make sure to use IP67 rated conduit for surface installations.