ILUMINARC Ilumipod™ 7 IP - Manual (Page 13)

Operation
Ilumipod 7 IP Optic RGBW User Manual (Rev. 4) 9
Refer to the
Operation
chapter or the
Ilumicon User
Manual to learn how to
enable the Ilumipod 7 IP
Optic RGBW to operate
with the ILUMICON
controller.
To assign
individual DMX
addresses to
each product,
you must connect the
Ilumicode controller to
each product, individually.
ILUMINARC®
suggests that you
connect no more
than 20 products
in this mode and keep the
total distance to less than
60 m (197 ft). Otherwise,
you might need to use an
optically isolated signal
amplifier.
ILUMICON
The Ilumipod 7 IP Optic RGBW can also work with the ILUMICON controller instead
of a standard DMX controller. Please refer to the ILUMICON User Manual to learn how
to use this controller with the Ilumipod 7 IP Optic RGBW product.
The figure below illustrates how to connect the ILUMICON controller to the Ilumipod 7
IP Optic RGBW.
Ilumicode
The Ilumipod 7 IP Optic RGBW uses the Ilumicode addresser for configuration
purposes. The diagram below shows how to connect the Ilumicode to this product. This
connection will control multiple products at the same time, all having the same DMX
address.
The Ilumicode must be used to configure the product. The Ilumicode can be purchased
separately through your Iluminarc sales representative.