ILUMINARC Ilumipanel™ 180 IP - Manual (Page 13)

Operation
Ilumipanel 180 IP Optic 15/30 RGBWA User Manual Rev. 12 9
If you have not
configured the
DMX starting
address and DMX
mode for each product,
they will all use their
default values. This
means that all products
will operate in unison.
Controllers
The products in the Ilumipanel 180 IP Optic 15/30 RGBWA can operate with a standard DMX
controller, the ILUMICON controller, or the Ilumicode addresser. The sections below will show
you how to connect these products to the corresponding controllers.
The instructions to operate these products with each of the above controllers are in the
Operation chapter of this manual. You may also choose to connect these controllers via W-
DMX™.
Refer to the W-DMX™ transmitter instructions provided with your transmitter and the W-
DMX™ Calibration section of this manual to use this method.
DMX Controller
The Ilumipanel 180 IP Optic 15/30 RGBWA products can work with a standard DMX
controller. The channel assignments will depend on the chosen personality (see the
Menu Map section) and the DMX address assigned to each product (see Programming
section).
The figure below illustrates how to connect the DMX controller to the Ilumipanel 180
IP Optic 15/30 RGBWA products.