Chapter 2 installation procedure, Installation – Holland Electronics NE 1101L User Manual
Page 8
- 8 -
Forward Optical Receiver
Operation Manual
Chapter 2 Installation Procedure
Checklist
Parts Qty
Hanger 1
set
AC power cord
1
Installation
The following are procedures to be followed in the installation of Rack Mount Forward Receiver(called as FRx in the
following description)：
1.
Before installing the FRx, check to make sure that enough space is provided for air circulation especially in the
Heat Sink portion of the FRx.
2.
Check the power plug of the supply and proper grounding to avoid damage to the FRx.
3.
Connect the AC power cord.
4. Connect
the
「RF Output」 coaxial cable.
5.
Lift the eye-safety shutter from the rear panel
「Optical Input」 fiber connector, and connect the jumper optical fiber.
Before connection, clean the connector and make sure that the connector type is SC/APC.
6.
Ch A Port of Optical input port is recommended as the Main loop. And use the Ch B Port as Backup loop.
Caution: Direct eye exposure to laser beam may cause physical damage,