Future Automation SPS User Manual
Page 9
In
st
all
at
io
n
: S
ta
ge
4
Page 8 of 28 // email [email protected] tel: +44 (0) 1438 833577 fax: +44 (0) 1438 833565
Positioning The Moving Panel Mechanism
Before the mechanisms can be fitted, it is important to decide on the exact positions
where they need to be.
Make sure that you have the mechanisms in the down and in position at this point.
With the mechanism in place,
measure the height that is needed
to achieve this position.
The mounting plates need to
be positioned roughly in the
middle of where the screen /
opening is located
Ro
ug
hly
4m
m
Mechanism
Height Needed
SPS SPLIT V & H - Sliding Panel System Split Vertical & Horizontal
The moving panel mechanisms should be positioned
roughly 4mm in from the edge of the enclosure.