Future Automation SPS - Manual (Page 8)

In
st
al
la
ti
o
n
:
S
ta
ge
3
Page 7 of 28 // email [email protected] tel: +44 (0) 1438 833577 fax: +44 (0) 1438 833565
Mark The Screen Position In The Enclosure
Firstly, mark where you intend the top of the
plasma screen to be on the back wall of the
enclosure.
Then mark a line showing where the centre of
the screen / opening will be.
It may be helpful to mark out the outline of the
whole plasma screen on the wall. This will
help when positioning the moving panel
mechanism.
SPS SPLIT V & H - Sliding Panel System Split Vertical & Horizontal
Line to mark top
edge of screen
Line to
mark centre
of screen