Future Automation SPS User Manual
Page 11
In
st
all
at
io
n
: S
ta
ge
6
Page 10 of 28 // email [email protected] tel: +44 (0) 1438 833577 fax: +44 (0) 1438 833565
Fitting The Drive Unit
It is important that at this point both
moving panel mechanism are in the
same down and in position.
Loosen bolt to allow
telescope. Re-tighten
once at length.
M5 x 35mm bolts with
nuts through both these
joints (both ends)
The panel drive unit is a telescopic
piece of equipment. Locate the 'motor
end' of the unit in the two couplers at
the top of the right hand moving panel
mechanism.
Then extend the drive shafts of the unit
until they locate in the couplers on the
left hand moving panel mechanism.
Then use the M5 x 35mm bolts and nuts
to secure the shafts in the couplers.
Left Hand
Mechanism
Right Hand
Mechanism
SPS SPLIT V & H - Sliding Panel System Split Vertical & Horizontal
Motor End
Telescopic End