Drylam Fujipla LPP6512 Roller Laminator - Manual (Page 6)

Page 6 of 12
Functions
1. READY Lamp (yellow)
Yellow lamp glows when the heat roller gets to the
desired temperature
2. TEMP C Lamp (yellow)
Lamp (yellow) indicates that temperature setting can be
adjusted
3. SPEED Lamp (yellow)
Lamp (yellow) indicates that speed setting can be
adjusted
4. TEMP/SPEED Switch
Change display of TEMP/SPEED:
TEMP C lamp: change of temperature is possible
SPEED lamp: change of speed is possible
5. DOWN Button
Temperature or Speed can be reduced
6. UP Button
Temperature or Speed can be raised
7. HEATER Switch
Rubber Roller is heated when this button position is ON (each time you
push the button, it will be switched into ON/OFF).
8. MOTOR Switch