Drylam Fujipla LPP6512 Roller Laminator - Manual (Page 4)

Page 4 of 12
SAFETY PRECAUTIONS:
For safe operation, be sure to observe following precautions.
Installation:
1. Do not install the Lamipacker in a humid, dusty area, or near an air conditioner.
2. Install Lamipacker on a level surface and leave enough space in the rear to guide laminated objects out the
exit.
3. Do not put anything on top of the Lamipacker.
4. Be certain that the power source connects to a dedicated and grounded AC120V 60 Hz outlet. Do not share
the electrical outlet with other devices.
5. Use in a well ventilated room.
Laminat ing film:

While genuine FUJIPLA "CP Roll" is recommended any quality 1.5 or 3 mil laminating film may be used.
Contact your dealer.
Laminating objects:
Lamination is made by heat and pressure. Inappropriate operation may cause failure in quality of lamination or in
jamming of film. Avoid lamination of the following:

Inflammable substances or any substance susceptible to heat (e.g. vinyl chloride, polyethylene, etc.)

Valuable items which are unique and not replaceable. Do not laminate money.

Lamination items which exceed 35mil. In total thickness.

Objects which change color or quality with heat (e.g. thermal paper, pictures drawn with crayon etc.)
Operation:

Operate the Lamipacker only for lamination of paper items.

Do not leave the Lamipacker during operation.
Changes or modifications not expressly approved by the party responsible for compliance could void the user's
authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to
part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in
a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the equipment off and on,
the user is encouraged to try to correct the interference by one or more of the following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help.
Contents