Drylam 27STA Roller Laminator User Manual
Page 4
23220 W. 84
th
St., Shawnee, KS 66227
Phone: (888) 633-1973
Brian Jennett- Tech-Line/Service Manager ext 8575
27STA Instruction manual.docx Page 4 of 24
• This unit should only be connected to a power supply outlet of the voltage, amperage and
Frequency marked on its serial tag.
• For 120 volt machines the socket outlet shall be installed near the equipment and be easily
accessible.
•For 240 volt machines a readily accessible disconnect device shall be incorporated in the
building installation wiring.
• The power supply cord should be routed so that it is not likely to be walked upon or pinched,
especially near the plug, convenience receptacles, or where the cord exits from the unit.
• Unplug the machine during any machine repairs.
• Clean unit only as recommended in this instruction manual.
• Make sure to remove the Feed Table before reversing the machine!
• Care should be taken so that objects do not fall, and liquids are not spilled, into the
enclosure through any openings.
• Caution: The Cutter blade is extremely sharp. Please handle carefully and dispose of
properly.
Save Your Carton! DryLam ships laminators in a special carton which protect them from
damage. Please store your carton in case your laminator should ever require servicing.
Remove the laminator from its box by grasping the housings and pulling up. Do not use rollers
or shafts as handles- this could cause damage.
The power supply cord should be unplugged from the wall outlet when it is to be unused for a
long period of time.
This manual is provided as an Operator’s Manual and covers most situations you will
encounter while using your laminator. It is not a Technical Service manual. For technical
assistance beyond what this manual provides, contact the DryLam Tech-Line at the email