Slitter kit – Drylam 27STA Roller Laminator User Manual
Page 21
23220 W. 84
th
St., Shawnee, KS 66227
Phone: (888) 633-1973
Brian Jennett- Tech-Line/Service Manager ext 8575
27STA Instruction manual.docx Page 21 of 24
SLITTER KIT
A slitter kit (item #202005 for 25" kit or item # 202000 for 27" kit) may be obtained from an
Authorized DryLam dealer.
Before installation please check
contents of your kit. Unplug the
laminator prior to installation.
Caution: Do not install kit if Heat
shoes are hot!
1) Molded on the back of the
Mounting Bracket are two pins.
These pins fit into the rivet heads. (See Figure 1) Hold the Mounting Bracket in place with the
pins in the rivet heads. Mounting bracket holes will be lined up with the side panel holes.
Secure with screws provided. Repeat on other side.
FIGURE 1
2) Take the thumb screws and screw one into each of the slitter bar locking blocks and slitter
assemblies. Do not tighten the thumb screws - only start them at this point.
3) Take the slitter bar and slide on one locking block, both slitters, and then the other locking