Doremi DCP-2000 - Manual (Page 5)

2 ShowVault Server Configuration
2.1 Server Configuration
Follow the procedure below for the cabling configuration:
• Connect an Ethernet cable to the ETH0 port on the Doremi server and connect the other end
to a Gigabit (1000) Switch. Connect an ethernet cable to the Command port on the Dolby
CP850 and connect the other end of the ethernet cable to the same switch you connected the
Doremi server to. (Figure 1 and Figure 3).
Note: The Dolby CP850 should be configured under the management/auditorium network and NOT
on the media network.
Important: The Doremi server will need to be able to communicate with the Dolby CP850
(Same sub-network/IP range).
• Refer to Figure 2 for an example of how the equipment should be connected.
D2K.OM.003651.DRM Page 5 of 33 Version 1.1
Doremi Labs
Figure 1: Doremi Server
Eth0
Port
Eth1
Port
PCI-e
Port