Doremi DCP to ShowVault Conversion Procedure - Manual (Page 11)

5 Conversion Procedure
• The lid needs to be removed. Unscrew the six screws with the Phillips screwdriver.
There are two screws on each side and two screws on the rear panel of the chassis
(Figure 21).
Figure 21: DCP-2000
• Once the lid has been properly removed, proceed to remove the Dolphin DCI card by
unscrewing the screw on the motherboard, located at H5G1, with the Phillips
screwdriver. See Figure 22 below.
Figure 22: Screw on the Motherboard
• Unscrew the screw holding the Dolphin DCI card on the top of the rear chassis (Figure
23).
Figure 23: Removing the Dolphin DCI Card
SHV.DP.001547.DRM Page 11 Version 1.4
Doremi Labs
Screw
Screw
Screw
Locations Screw
Locations