Dataman 530 Series - Manual (Page 35)

DATAMAN 530 series AWG
User’s Guide
6. Performance characteristics
6.1. Outputs
Number of channels 1
Number of outputs 2, low and high level (L a H)
Output attenuator Settable to 0 or -20dB on L output
Max. output voltage, output L, no load -4.5V to 4.5V (9Vpp) attenuator set to
0dB
-450mV to 450mV (900mVpp) attenuator
set to -20 dB
Max output voltage, output H no load -25V to 25V (50Vpp)
Recommended range of output voltage
setting, output L, no load 800mVpp to 9Vpp attenuator set to 0dB
80mVpp to 900mVpp attenuator set to
-20 dB
Recommended range of output voltage
setting, output H, no load 4.6Vpp to 50Vpp
Output voltage setting step, output L, no
load < 2.5mV (attenuator set to 0dB)
< 250uV (attenuator set to -20 dB)
Output voltage setting step, output H, no
load < 13mV
Output voltage setting accuracy Output L: +-2% from the actual value in
recommended range up to 10 MHz.
Output H: +- 2.5% from actual value in
recommended range up to100 kHz
+-5% from 100kHz to 200kHz
Output voltage shift range, output L, no
load +-1.5V attenuator set to 0dB
+-150mV attenuator set to -20 dB
Output voltage shift range, output H, no
load +-8V
Shift setting accuracy, output L +-1.5% from whole range
Shift setting accuracy, output H +-2% from whole range
Output resistance, output L 50Ohm
Output resistance, output H 600Ohm
Output resistance accuracy, output L +-1.5% attenuator set to 0dB
+2%, -0.5%, attenuator set to -20 dB
Output resistance accuracy, output H +- 1.5%
Filter Settable to 20MHz, 40MHz or off
Output pulse edge length, output L < 10ns, filter off
Output pulse edge length, output H < 2.5us
Short circuit protection Unlimited
Table 6.1.1. – Outputs
6.2. Waveform generation
Waveform memory length 8192 samples in “standard“ mode,
maximally 16384 samples in „arbitrary“
mode
- 35 -