Dataman 530 Series - Manual (Page 14)

DATAMAN 530 series AWG
User’s Guide
Fig. 4.1.1. – Outputs settings
Using these elements it is possible to control amplitude and DC shift of the output
waveform. It is also possible to display the proper amplitude depending on the
connected load and set the low pass filter cut-off frequency.
4.1.1 Setting the output voltage
The output voltage can be adjusted by dragging the vertical scroll bar labeled “Lvl”.
The output level can be set also relatively to the reference value, which is displayed in
the edit box labeled “dB”. The reference value can be set in following two modes:
- Auto dB - the reference value is continuously adjusted to the output level.
Please note that the “dB” edit box always displays 0 in this mode.
- Man dB - the edit box (“dB”) shows the relation of output level value to the
reference value. Clicking the “Set 0 dB” button sets the reference value to the current
output level.
It is possible to set the output level in following manner:
- Enter the value into the “dB” edit box
- Enter the value into the “Vpp” or “Vp” edit boxes.
- 14 -