Dataman S4 Validator - Manual (Page 22)

S4 VALIDATOR MANUAL
22 Important Notes
•
Push and hold in the RESET button for
approximately 30 seconds. The RESET
button is accessed through the small hole
located next to the ON/OFF switch. Use a
fine point pen/pencil or a paper clip to
reset the S4 Validator. Do not press hard,
the reset is a push button switch with short
travel.
•
Release the RESET button and push the
power switch to the on or up position.
•
The display should read “Start Library?”.
Press the ENTER button. Your current
library should now be displayed.
•
Press the INFO button and make sure that
your charger is being sensed and that it is
turned on. If it is not turned on, press the
RIGHT ARROW button, this will manually
turn on your charger.
•
Once the charger has been manually
turned on, push the power switch to the off
or down position. Your display should now
read “Will switch off when charging
completed”.
•
When your display goes blank, unplug
your charger. Your S4 Validator is now
fully charged and ready for use.
If performing the above procedure fails to start
the S4 Validator please contact Dataman for
Technical Support.