Diamond Systems C-PGS-KIT - Manual (Page 12)

Pegasus Fast Start Guide 7460572 Rev A Page 12 of 12
CONFIGURING IDE DEVICES
The on‐board PCI IDE connector supports two IDE devices: a primary master and a primary slave. The
supported IDE devices include the on‐board flashdisk, a CompactFlash disk, a flashdisk plug in module on
the IDE connector, or external IDE devices. You can configure the system’s IDE devices from the BIOS’s
Standard CMOS Features screen. Many devices have on‐board jumpers for configuring itself as a master
or slave. Consult the device’s User Manual for details.
The possible IDE device combinations for the two Pegasus models are as follows:
Model: PGS800‐256‐2G
Master Slave
Device on IDE Connector 2GB on‐board flashdisk
CompactFlash Disk 2GB on‐board flashdisk
The 2GB on‐board flashdisk on Pegasus model PGS800‐256‐2G is fixed as the primary slave device and
defaults to drive C: if no other bootable device is found. If a bootable device is found as the primary
master, the on‐board flashdisk is assigned drive D:. This model does not allow for devices on the IDE
connector and a CompactFlash disk to co‐exist.
Model: PGS800‐256
Master Slave
Device on IDE Connector Device on IDE Connector
CompactFlash Disk Device on IDE Connector