CUE PEX - Manual (Page 13)

4.2. Configuration of one channel dimming modules PED 108, PET
102 and PET 105
PED108 is a one-channel dimmer for resistive and inductive loads up to 8 A. PET102 is a one-channel
dimmer for resistive and capacitive loads up to 2 A suitable for dimmable electronic transformers.
PET105 is a one-channel dimmer for resistive and capacitive loads up to 5 A suitable for dimmable
electronic transformers.
Fig. 12
4.2.1. PED 108, PET 102, PET 105 parameters description
• Interface address 0-31 address of the module. The addresses of both channels of this module
are based on this value.
• Bank 0-9 module group
• Filter 0-180 msec. minimum time of pressing the button for the press to be valid.
• Long press 0-900 msec. If time of pressing the button is longer than this value, the press is
interpreted as a long press.
The following parameters can be set for each channel independently:
• Function mode selection for control dimmer by it’s buttons
− no action - buttons are disabled.
− toggle - switch outputs between maximum and minimum values.
− solid state - if no button is pressed, the output value has the minimum value. If one button is
pressed, the output has the value entered in the parameter Intermediate. If both buttons are
pressed, the output has the maximum value.
− dimmer – a short press of the UP/DOWN button changes the output value to
maximum/minimum at the speed set in the parameter Short press fade. A long press makes
the output dim up/down at the speed set in the parameter Long press fade. A release of the
button makes it stop at the currently reached value.
− Short press fade - speed of dimming in case of normal button press, 0-99.9 sec.
− Long press fade - speed of dimming in case of long time button press, 0-99.9 sec.
− Minimum - minimum output value, 0-99 %.
− Maximum - maximum output value, 0-99 %.
− Intermediate - intermediate output value, 0-99 % for solid state mode.
User Manual PEX Software
www.cue.cz
Page 13 of 25