CUE PEX - Manual (Page 12)

− run – a short press switches the relay on for the period of time entered in its parameter. Long
time press do the relay on only for button is holding. It is useful in couple with other channel
with direction mode for controlling of AC motors.
− direction - it is useful for selecting direction of controlled AC motors. After 200 ms the couple
relay with mode run is switched on too.
− delayed off - the relay is switched on at once, but it is switched off after delay time.
− delayed on - the relay is switched off at once but it is switched on after delay time.
− run DC (firmware 1.09 or higher) - short press switch relay on for parameter time. Long time
press do the relay on only for button is holding. It is useful in couple with other channel with
same mode for controlling DC motors.
− pulse (firmware 1.10 or later) – the relay is switched on for a short time impulse entered in the
parameter.
• Time parameter in seconds for modes working with time. There are the following time formats
available for units with firmware 1.11 or higher:
− seconds 0,1 – 999,9 s
− minutes - seconds: 00:01 – 59:59
− hours - minutes: 00:01 – 12:59 (longest avilable time is 12 hours 59 minutes)
• Label - Channel legend which can consist of up to 22 characters.
•
4.1.2. Direct control of the channels
Fig. 11
If you check off the On-line box, the current state of the on- and off- outputs is shown next to the
channel names, being constantly updated. An output that is off is indicated by an activated button.
Clicking the button of the desired channel causes the negation of the output state.
User Manual PEX Software
www.cue.cz
Page 12 of 25