CUE PEX - Manual (Page 11)

4.1. Configuration of the PER 610 module
PER610 is a six-channel relay switching unit for loads up to 10 A per channel. There are all
changeable parameters in the configuration window of the module. The parameters in the upper part
of the window are shared by all channels of the module.
Fig. 10
4.1.1. PER 610 parameters description
• Interface address 0-15 address of the module. The addresses of all channels of this module are
based on this value.
• Bank 0-9 module group
• Filter 0-180 msec. minimum time of pressing the button for the press to be valid.
• Long press 0-900 msec. If the time of pressing the button is longer than this value, the press is
interpreted as a long press.
The following parameters can be set for each channel independently:
• Function mode selection for control relay by its buttons
− no action - buttons are disabled.
− coded - Each press causes the negation of the relay state (switched on/off)
− relay - When button is pressed, the output is on, otherwise it is off.
− system on - When pressed, the relay switches on; it can be switched off only by a command
through serial line.
User Manual PEX Software
www.cue.cz
Page 11 of 25