CP Electronics VITP-PD - Manual (Page 2)

LOAD
See datasheet for Vitesse Plus marshalling box
SUPPLY VOLTAGE 12VDC
TIME OUT PERIOD Adjustable 10 seconds to 30 minutes
LIGHT LEVEL Light to dark
FIXING METHOD Flush fixing in 64mm hole
MATERIAL Flame retardant ABS
TYPE Class 2
TEMPERATURE -10°C to 35°C
CONFORMITY EMC-89/336/EEC
LVD-73/23/EEC
LOAD DOES NOT COME ON
Check to see if the Vitesse Plus marshalling
box is powered up and the wiring is correct.
If the supply and wiring are good, check the
LUX level setting. Increase the LUX level set-
ting to allow the controller to turn on at higher
ambient natural light level.
If the detection range is smaller than expected,
check the diagram above. Rotating the sensor
slightly may improve the range.
LIGHTS DO NOT GO OFF
Ensure that the area is left unoccupied for
longer than the selected timer setting.
Make sure that the sensor is not adjacent to
circulating air, heaters or lamps.
Part Numbers
Fault Finding Specification
Detection Pattern
VITP-PD Vitesse Plus ceiling mounted presence detector
DBB Surface mounting box
Ref #WD156 Issue 4
C.P. Electronics Ltd
Brent Crescent
London
NW10 7XR
United Kingdom
Tel:
+ 44 (0) 333 900 0671
Fax: + 44 (0) 333 900 0674
www.cpelectronics.co.uk
[email protected]
IMPORTANT NOTICE!
This device should be installed by a
qualified electrician in accordance with
the latest edition of the IEE wiring
regulations.
Due to our policy of continual product improvement CP Electronics reserves the right to alter the specification of this product without prior notice.
FM 45789 EMS 534520