CP Electronics VITM4-EBMHS-PRM - Manual (Page 3)

3
The product is designed to be mounted directly to a luminaire, either on the inside or outside. The detector should be
sited so that the occupants of the room fall inside the detection pattern (shown opposite), at a recommended ceiling
height of 2.8m. Note that the lower the sensor is installed the smaller the detection range will be, subject to the
parameters shown on the detection diagram.

For optimum operation of the lux sensor, the lens must shielded as much as possible from the light source.
 If flush mounting in a panel >6mm thick, remove bottom of retention arms with side cutters.
 Avoid direct sunlight entering the sensor.
 Do not site within 1m of forced air heating or ventilation.
 Do not fix to a vibrating surface.
Installation
Detection mode
 Presence When movement is detected the load will automatically turn on. When the area is no longer occupied the
load will automatically switch off after an adjustable time period.
 Absence The load is manually switched on. When the area is no longer occupied the load will automatically switch
off after the adjustable time period has elapsed.
 Switch operation:
PRM single switch: short press turn on, long press turn off.
EBMHS-DD & EBMHS-AD single switch: short press turn on, short press turn off, press and hold cycles dimming.
EBMHS-DD & EBMHS-AD two way switch: up button short press turns on, press and hold to dims up. Down
button short press turns off, press and hold dims down.
In either case, sensitivity to movement of the PIR sensor can be adjusted using the Sensitivity parameter.
HINT: To assist in setting the Sensitivity, turn on the Walk Test LED which will flash red when movement is detected.
Switch Level On/Off
Occupancy detection can be made dependant on the ambient light level using the Lux On Level and Lux Off Level
parameters.
Maintained Illuminance (daylight harvesting) - DD and AD variants only
The detector measures the overall light level in the detection area and calculates the correct output for the luminaires, to
achieve a preset lux level (maintained illuminance or daylight harvesting).
Burn-in - DD and AD variants only
 Overview
It is a requirement of many fluorescent lamp manufacturers to have the lamps on at maximum output for a period of
time to guarantee lamp life (refer to the manufacturer’s datasheet for details). As the EBMHS-DD & AD are able to
dim the lamps using DALI/DSI or 1-10V, the products provide a facility to disable this for a given period of time.
 Operation
By setting the “Burn in” parameter, you can select a time during which the lamps are not allowed to deviate from
maximum output. The unit counts the time, and even remembers how long has elapsed in the event of a power
failure. To cancel the burn in function, simply select a time of 0. Note that when the lamps are changed, the burn in
time should be set again.
Sensor functionality
Burn-in - DD and AD variants only