COMMELL MPX-2515 - Manual (Page 4)

Commell MPX-2515 User’s Guide Rev 0101
Taiwan Commate Computer Inc. 4
1 Technical Guide
1.1 Introduction
The MPX-2515 CAN 2.0B USB card is a USB 2.0 compliant device, which
implements Controller Area Network (CAN) version 2.0B interface. This card is
made in Mini-PCIe form factor so that this module is able to insert into motherboards
that provide Mini-PCIe slot, like most Commell motherboards do. In addition, users
are able to connect this card to an USB Type A receptacle that most PC has by using
the OALUSB-H4-1 optional cable. MPX-2515 CAN 2.0B USB card provides the
following features.
1.1.1 Features
• USB 2.0 Full Speed compliant
• Controller Area Network (CAN) version 2.0B
• Implement ISO-11898 Standard Physical Layer
• Supports 1 Mb/s operation (recommend 125 Kbps)
• Default to 125 Kbps
• On board 120 Ohm line terminator (enabled/disabled by jumper)
• 0 to 8 byte length in the data field
• Standard and extended data and remote frames
• Two receive buffers with prioritized message storage
• Six 29-bit filters
• Two 29-bit masks
• Data byte filtering on the first two data bytes
• One-shot mode ensures message transmission is attempted only one time
• Typical 5 mA active current
• Typical 1 uA standby current (sleep mode)
• Externally-controlled slope for reduced RFI emissions
• Detection of ground fault (permanent Dominant) on TXD input
• Power-on Reset and voltage brown-out protection
• Protection against high-voltage transients
• Automatic thermal shutdown protection
• Up to 112 nodes can be connected
• High-noise immunity due to differential bus implementation
• IEC 61000-4-2 (ESD) ± 15kV (air/contact) protection
• IEC 61000-4-4 (EFT) 50A (5/50ns) protection
• Produced in Mini-PCIe card form factor (easily locked on motherboard)