Directed Electronics 732T - Manual (Page 15)

Extra disarm chirps are the Tamper Alert. If four chirps are heard
when disarming, the system was triggered in your absence. If five
chirps are heard, a zone was triggered so many times that
Nuisance Prevention Circuitry has bypassed that zone. In either
case, the Status LED will indicate which zone was involved (see
Table of Zones section). The system will retain this information in
its memory, and chirp four or five times each time it is disarmed,
until the next time the ignition key is turned on.
Table of Zones
The zone number is the number of LED flashes used by the system
to identify that input. The standard input assignments are listed
below, along with spaces to write in any optional sensors or
switches you have had installed.
ZONE
(Number of DEALER-INSTALLED
LED Flashes) DESCRIPTION OPTIONS
2 Instant trigger - a heavier impact
detected by the Double Guard
®
Shock Sensor
3 Door switch trigger
4 Optional hood or trunk pins or
optional sensors
5 Ignition trigger
NOTE: If the Warn Away ® response is triggered, the LED will not report it.
Disarming Diagnostics
12 © 2000 Directed Electronics, Inc.