Doro 930R - Manual (Page 5)

English
www.doro.com 5
Installation
Unpacking
The package contains:
- Handset - Mains adapter
- Base unit - Line cord
- 2 batteries
Models with an extra handset (+1) also include an additional handset, batteries, charger and
mains adapter*.
IMPORTANT!
Only use with the supplied power adapter/s. *Connect the correct adapter according to the colour indication/markings.
Connection
1. Connect the mains adapter to the y socket on the base unit and to an electrical wall
socket.
2. Carefully remove the battery cover from the back of the handset by inserting a pointed
object into the small hole in the bottom of the handset, e.g. a pen or similar. Insert the
batteries into the handset and ensure correct battery polarity is observed, replace the battery
cover.
3. Place the handset in the base unit, with the keypad facing outwards. Once the handset is
correctly positioned in the base unit, a beep will be heard.
4. Leave the handset to charge initially for 24 hours before use.
5. Plug into the telephone network wall socket.
6. Connect the line cord to the telephone plug and the T socket on the base unit. T T
7. Select a language following the description on page 19.
Only for models with an extra handset (+1):
8. Connect the additional charger’s mains adapter* to the y socket on the charger and to
an electrical wall socket.
9. Carefully remove the battery cover from the back of the handset by inserting a pointed
object into the small hole in the bottom of the handset, e.g. an unfolded paperclip. Insert
the batteries into the handset and ensure correct battery polarity is observed, replace the
battery cover.
10. Put the additional handset in the charger, with the keypad facing outwards.
11. Leave the handset to charge initially for 24 hours before use.
Please note!
Under power failure conditions this telephone will not operate. Please ensure that a separate telephone not dependent
on local power is available for emergency use. Do not place the base unit close to other electrical equipment such as
TV sets, computer screens, telecom equipment, fans etc. This will minimise the risk of interference. Do not place the
base unit in areas where it will be exposed to direct sunlight or other major heat sources. Only use with the supplied
power adapter/s. *Connect the correct adapter according to the colour indication/markings.