Doro 930R - Manual (Page 29)

English
www.doro.com 29
The answering machine
Recording an Outgoing Message (base unit)
1. Press and hold
!
until you hear “Please select outgoing message”.
2. Press
8 8
for the normal outgoing message (OGM) or
9 9
for Answer only
(ANN).
3. The display will fl ash
P1
(OGM) or
P2
(ANN). The selected message will
be heard.
4. To record your OGM message press and hold
8 8
. You will hear a short
beep and the display will fl ash.
5. To record your ANN message press and hold
9 9
. You will hear a short beep
and the display will fl ash.
6. When recording speak clearly towards the top of the base unit from a
distance of approximately 15-20 cm.
7. Release the button (
8 8
Release the button ( Release the button ( /
9 9
) to stop recording.
9 9 9 9
8. The message will be replayed after a few seconds.
Repeat this procedure if you wish to change the OGM/ANN message. Any old
OGM/ANN message will automatically be erased when a new one is recorded.
Please Note!
Recording your outgoing message (OGM) through the handset (command
83
) could improve
83 83
sound quality, please refer to page 35.
Reset the OGM to the factory message (base unit)
This allows you to reset the OGM back to the original factory message.
1. Press
!
until you hear “Answer On, your outgoing message is”.
2. While the OGM is playing press C.