Doro 930R - Manual (Page 39)

English
www.doro.com 39
Other
The answering machine is not answering
- Memory may be full. Listen to your messages and erase them.
- Check that the unit is switched on
- Check that the telephone cable and the mains adapter are correctly
connected
The answering machine does not respond to remote control
-
Check that the telephone you are using to remotely control the answering
machine is a tone dialling telephone.
- Some telephones only emit a short tone beep when buttons are pressed,
and this may not be enough to activate remote control Use a separate tone
transmitter in these cases.
- Also try holding the buttons down longer, approximately 1 second per
digit.
The base unit/answering machine emits a regular beep tone
-
The Message Alert feature has been programmed on, to turn this off refer
to page 32.
The answering machine does not respond to any commands or button
presses
- It may be necessary to reset the unit. Disconnect the telephone line and
power connections wait for a short time and then re-connect, this will
reset the machine. If there are still problems with the operation please
contact our support departments.
If the telephone still does not work, contact your local Doro Support
department or the place of purchase. Don’t forget the receipt or copy of the
invoice.