D-Link DI-704P - Manual (Page 11)

-11-
Rear Panel
PRINTER
Parallel port connector (25-pins D-type female.) This is where you will
connect the shared printer. (Optional)
COM Serial port connector (9-pins D-type male.) This is where you can connect
a back-up dial-up modem. This port is also a console port.
WAN WAN port socket (CAT5 Ethernet RJ-45 cable). This is where you will
connect to your cable or DSL modem.
PORTS
1-4 LAN port sockets (CAT5 Ethernet RJ -45 cable.) The LED glows steadily
when a port is connected to a hub, switch or network -adapter-equipped
computer in your local area network (LAN.)
Installation Requirements
The DI-704P can be positioned at any convenient place in your office or house.
No special wiring or cooling requirements are needed. However, you should
comply with the following guidelines:
l Place the DI-704P on a flat horizontal plane.
l Keep away from any heating devices.
l Do not place in a dusty or wet environment.
The recommended operational specifications of the DI-704P are:
Temperature 32
o
F ~ 131
o
F
Humidity 5 % ~ 90 %
In addition, remember to turn off the power, remove the power cord from
the outlet, and keep your hands dry when you install the hardware.