AXING SKT 2-01 - Manual (Page 12)

Programming
SKT-2-01
© AXING AG – state of the art: July 2012 – Reserving change in design and type Page 12
Select menu item "Select program info" by
pressing the OK-button. A list with all available
channels and all corresponding pre
programmed data appears.
Fig. 19 List of available channels
Make sure that the selected SAT position is
available. SAT-position A is pre programmed
for Astra19,2°E and B contains the data of Hot
Bird 13°E. The last column gives information
about, if channel is free to air (FTA) or if it is
encrypted. In that case a common access (CA)
module is required.
Press CH /CH to scroll step by step
Press / to scroll in 10-steps at once
Select the program by pressing OK
Sub menu scan transponder is shown.
Transponder data are applied automatically of
the list.
Change to scan by pressing CH .
Start he scan by pressing OK.
It will take a fiew seconds.
After "please wait", "scan transponder" and
"transponder data found" appeared on display
the channel list will be opened.
Fig. 20 Display during scanning a Transponder
4.5.6 Dynami c SI
This function is only relevant for Austria. This
function is used to switch the ORF regional
switchover on or off.
Select menu item "Dynamic SI" and press OK
to confirm.
To activate the function, press the VOL /
VOL keys.
4.6 Channel list
After transponder scan channel list is being
displayed. It can also be chosen and opened
via main menu.
All programs that were found on transponder
will be shown.
Fig. 21 Channel list
Behind the program names appears (FTA) for
free to air programs and (CA) for scrambled
ones and at the end of each line at first a minus
-.
SYS -button selects between +, - or $.
• programs marked with + will be transmitted
• programs marked with - won't be transmit-
ted
• CA programs, which should be encoded in
the headend, need to be signed with a $.
Important: Press OK if the programs to be
transmitted are selected. The cursor must be
positioned on a program marked with + or $.
The program on which the cursor is set will be
transmitted to analogue output ( RCA-socket)
This happens only in case that configuration -
video start up- MPEG2 SD monitor is selected.
After approx. 5 seconds "reading services,
please wait" appears on the display.
Wait until this display disappears
LCN (logical channel numbering)
In channel list, programs are numbered
continously. This numbers can be edited by the
help of the keys in number field of the remote
control. With it a new mapping of programs can
be done. The end device must support the
LCN-function.
!
!