Atlona AT PRO3HD66M User Manual

Page 14

atlona.com

Toll free: 1-877-536-3976

Local: 1-408-962-0515

TCP/IP

Warning!: Do not connect the matrix LAN port until the first steps have been followed.

BEFORE YOU PLUG IN ANYTHING: Verify no other devices on the network have the IP of
192.168.1.10 (the matrix default is 192.168.1.10).

(

See page 12 to view the IP through the front panel

)

There are two ways to set TCP/IP control when any of the products on the network have the same
IP address as the matrix: RS-232 or through LAN on a non networked computer.

RS-232 TCP/IP Set up (Preferred)

LAN TCP/IP Set up (If RS-232 is not available)

Step 1: Follow RS-232 set up instructions on page 13
Step 2: Open Hyperterminal program
Step 3: Verify DHCP is off

Send command “IPDHCPsta” followed by a carriage return

Feedback should be “DHCPoff”

If DHCP is on use command “IPDHCPoff” to turn DHCP off

Step 4: Change the current IP using the command “IPStatic

192.168.0.200 255.255.255.0 192.168.0.1

”

IP can be anything that system devices aren’t currently using. (200 is just an example)

Step 5: (optional) Change the port using the command “IPPort 4400” followed by a carriage return

4400 is just an example. The port can be changed to what is needed/wanted

The matrix is now ready to be used for TCP/IP control. The LAN cable may be connected now.

Step 1: Connect LAN to a computer
Step 2: Right click the network icon at the bottom right side of screen and

open network and sharing center on PC (see picture A)

Step 3: Select internet type connection/local area connection (see picture B)
Step 4: Select properties (see picture C)
Step 4: Select IP V.4 and press properties (see picture D)

Router IP address