Applied Motion 1035D - Manual (Page 7)

-7- -10-
Motor Size Winding Max Torque Current
Number inches Connection oz-in Amps
5014-842 1.38 x 1.38 x 1.57 4 lead 22 1.0
5017-006 1.65 x 1.65 x 1.34 center-end 10 1.0
5017-009 1.65 x 1.65 x 1.54 center-end 17 0.8
5017-013 1.65 x 1.65 x 1.85 center-end 24 0.8
HT17-068 1.65 x 1.65 x 1.30 parallel 22 1.0
HT17-072 1.65 x 1.65 x 1.54 parallel 34 1.0
HT17-076 1.65 x 1.65 x 1.85 parallel 54 1.0
4023-839 2.22 x 2.22 x 1.5 center-end 35 1.0
4023-819 2.22 x 2.22 x 2.0 center-end 56 1.0
HT23-393 2.22 x 2.22 x 1.54 parallel 34 1.0
HT23-396 2.22 x 2.22 x 2.13 parallel 110 1.0
HT23-399 2.22 x 2.22 x 2.99 parallel 140 1.0
Recommended Motors
The following motors from Applied Motion Products are recommended for
use with the 1035D. All motors in the list have been tested with the 1035D.
Dynamic torque data is available.
Connecting A Pulse Source
The 1035D inputs contain optical isolation
circuitry to prevent the electrical noise inherent
in switching amplifiers from interfering with your
circuits.
Optical isolation also allows the 1035D to accept
step and direction signals ranging from 5 to 24
volts. Furthermore, the input signals can be
sourcing (PNP) or sinking (NPN), depending on
how you connect the COM terminal.
A schematic diagram of the input circuit is at the
right. The wiring diagrams below show how to
connect the drive to various pulse sources.
2200
2200
inside 1035D
COM
STEP1
DIR1
2200
2200
STEP2
DIR2
+5 VDC
STEP–
DIR–
1035D Si-100
1035D
SI-1
COM
STEP
DIR
Connecting Applied Motion Si-100
+5 VDC
STEP
DIR
COM
STEP
DIR
Connecting Applied Motion SI-1