Applied Motion 1035D - Manual (Page 4)

3362
3362
0-1A
0-1A
A+
A–
B+
B–
A+
A–
B+
B–
STEP
DIR
COM
DIR
STEP
1035D
axis 2 current
adjustment
step & direction
inputs
axis 2 motor
connector
axis 1 motor
connector
axis 1 current
adjustment
power
connector
12-35 VDC
-4- -13-
Mechanical Outline
3362
3362
0-1A
0-1A
A+
A–
B+
B–
A+
A–
B+
B–
STEP
DIR
COM
DIR
STEP
1035D
2.40 1.00
2.75
3.55 3.90
Getting Started
To use your Applied Motion Products motor control, you will need the following:
• a 12-35 volt DC power supply for the motor. Please read the section
Choosing a Power Supply for help in choosing the right power supply.
• a source of step & direction signals (indexer, oscillator or PLC).
• a source of power to activate the optoisolation circuits. Many indexers & PLCs
have power available for this purpose. If not, you may need a small 5 - 24 VDC
power supply.
• a small flat blade screwdriver (0.1" wide) for tightening the connectors and setting
the current.
The sketch below shows where to find the important connection and adjustment
points. Please examine it now.
axis 1
axis 2
axis 1
axis 2