MIPRO act707s-ii(2ce149)b - Manual (Page 9)

ACT SINGLE CHANNEL WIRELESS RECEIVER ACT SINGLE CHANNEL WIRELESS RECEIVER
A C T
ACT ACT EXIT
Operation of ACT Feature:
A. Operating Procedures.
B. How to Operate?
a. At LCD panel displays "Group" and"Channel" mode keystroke "ACT"
button . ACT mode is activated when "ACT" word appears on the
LCDpanel.
b. Move microphone toward to receiver within the distance around30cm,
and face the "ACT" marked side on the microphone to the "ACT"
button on the panel of receiver , see belowfigure.
c. ACTfunction will release automatically once the transmitter channel is
locked
on. Simultaneously, "Group" a n d "Channel" mode will be
backshowing on the LCD panel. Both transmitter and receiver
should show the same "Group" and "Channel". This indicates
transmitter frequency set-up is successful. If unsuccessful, repeat step
"A".
7. COMPUTER NETWORK INTERFACE OPERATION
1. Except for receiver module, both receiver with LCD display have the most
advance function of computer-network-interfaced controlling system.
2. Wiring Instruction
② Please connect one end of the phone cable (included) to remote connector's
"OUT" jack (9) on the back of the first receiver and connect the other end of
cable to remote connector's "IN" jack (9) on the back of second receiver.
(Shows in figure 9). Continue such parallel connection with remaining
receivers. Once all receivers are parallels connected, connect a phone cable
from remote connector's "IN" jack (9) on the back of first receiver to MIPRO-
DV converter.
① Connect the network interface remote connector (9) on the back of the
receiver to the interface converter (requires at least 2 linking cables for each
pairing). Then, use RS-232 cable connects the converter to the RS-232 COM
PORT on the computer.
(Fig.9)
1 4 15
CONVERTER
T O P C R S - 2 3 2 C O M P O R T T O P C KEYBOARD CO NNECTOR
TO KEYBOARD CONNECTOR
RX1
RX2
RX3
PC
ACT
MENU
GROUP
SCAN