MIPRO act707s-ii(2ce149)b - Manual (Page 3)

1 2 3 4
2 3
ACT SINGLE CHANNEL WIRELESS RECEIVER ACT SINGLE CHANNEL WIRELESS RECEIVER
2. PARTS NAME AND FUNCTIONS
Front Panel：
Rear Panel：
(Fig.1)
(Fig.2)
(1) Front Antenna A Input Connector : Allows an optional rear-to-front
Antenna kit for front antenna placement.
(2) Power Switch & Indicator: When switch is turned on, red indicator
illuminates to denote normal power status.
(3) Receiver Panel : Color LCD Panel.
(4) Front Antenna B Input Connector : Allows an optional rear-to-front
Antenna kit for front antenna placement.
(5) Antenna B input Connector: Antenna B connector can be installed with
antenna directly and provides power for antenna booster.
(6) Balanced Audio Output Jack: With Cannon / XLR type connector provides
balanced audio output signal from this jack to the amplifier.
(7) Unbalanced Level Switch: "MIC" selection is for "Microphone-level" output.
"LINE" selection is for "Line-out" level output.
(8) Unbalanced Audio Output Jack: With 1/ 4 Phone Jack provides audio
output signal from this jack to the amplifier.
(9) Computer Network Interface Connector: Network socket to connect to the
computerized system-monitoring program.
(10) DC Input Socket: The input socket for 12 Volt DC power. Please note
that the polarity of the central pin in the socket is positive (+).
(11) Antenna A Input Connector: Antenna A connector can be installed with
antenna directly and provides power for antenna booster.
(12) Rackmount Bracket: To install the receiver into an EIA 19-inch standard
rack case.
λ
5 6 7 8 10 11 9 12
RF A F
MHz
G / C H V O L FREQ SQ REMO N A M E BAT ANT B A
ACT
M E N U
G R O U P
S C A N