Belt pack transmitter – MIPRO act707s-ii(2ce149)b User Manual

Page 14

BELT PACK TRANSMITTER

2 4

4. FUNCTIONS OF LCD DISPLAY

(Fig.4)

(Fig.3)

5. BATTERY INSTALLATION

1. Pushing down both snap locks on the sides of battery cover to open battery

cover. Take out the batteries. Fig. 3).

2. Insert a two 1.5(AA) batteries into the battery compartment according to the

correct polarity as shown in Fig. 3). Then push up to close the battery
compartment as shown in Fig. 4).

PS: When the microphone is not in use:

Make sure the power of the microphone is off. If the microphone will not
be used for some time, please remove the batteries from the battery
compartment to avoid battery leakage and result in damaged battery
springs and circuit. If a rechargeable battery was used, take it out and
recharge it.

E R R

GROUP CHANNEL BAT

ERR no01

EEPROM is not being programmed or internal data error.

ERR no02

For testing only.

ERR no03

The frequency you are about to program into the system exceeds

microphone's upper limit. (At this time, microphone is still
operatable and the frequency remains unchanged. To clear the
"ERR" message in LCD display, simply turn off the power and
switch back on.)

ERR no04

The frequency you are about to program into the system is below

microphone's frequency lower limit. (At this time, microphone is still
operatable and the frequency remains unchanged. To clear the
"ERR" message in LCD display, simply turn off the power and
switch back on.)

→

2. "Group" & "Channel " : When both items are shown, they indicate that the user

is currently using the pre-programmed frequency in the receiver.

3. "Channel" Only : If "Channel" is the only item shown in the display, it indicates

the user is using the personalized frequency.

4. Battery Status:

Battery Status: When the battery has less than 10% power remaining, batteries

must be replaced. If undervoltage continues, LCD will show "PoFF" and shut down
the system to avoid battery being over-discharged.

100%

80%

40%

10%

5. Switch Off:

When switch the power knob to "Off" position, LCD will show "PoFF" first.

Then, the system is completely shut down and no further message will be
displayed.

1. ERR Message: When "ERR" appears, it means "Operation Error". Please refer

to the following codes to diagnose which error you are experiencing.