MIPRO act707s-ii(2ce149)b - Manual (Page 13)

BELT PACK TRANSMITTER BELT PACK TRANSMITTER
2 2 23
3. AF 4-PIN INPUT CONNECTION METHODS
(1) 2-Wire Electret Condenser Microphone Capsule
(2) 3-Wire Electret Condenser Microphone Capsule
(3) Dynamic Microphone
(4) Electric Guitar
(5) Line-in (Impedance 8K ATT. 10dB) Ω
AUDIO
SHIELD
4
3
2
1
PIN
SHIELD
AUDIO
BIAS
3
4
PIN
1
2
AUDIO
SHIELD
1
4
3
2
PIN
SHIELD
AUDIO
3
2 1
PIN
4
3
2
1
SHIELD
AUDIO
1
3
4
2
PIN
1 3
4
2
1 3
4
2
1 3
4
2
1 3
4
2
1 3
4
2
1 3 4
2 OFF ON BATT.
LOW
2. OPERATING INSTRUCTIONS
1. To adjust GT/MT Switch (10), and Gain Control (8), simply push down both
snap locks on the sides of battery cover and flip it backwards to expose the
adjustment panel.
2. Before power on, ascertain if same channel (7) was set up for both receiver
and microphone. If not adjust to same channel accordingly.
3. The LED indicator flashes briefly when power on indicating normal battery
status. If no flash occurs it has either no battery, the battery is drained or
installed incorrectly. Change accordingly.
4. Plug the microphone connector into the input jack (1) and tighten the
connector screw by clockwise direction as shown in (Fig. 2).
(Fig.2)
Lavalier
Headset Pleaseaim of
thefillister
andinsert t h e
connector
CapsuleConnector
1 3
4
2