Subaru 2007 Impreza WRX User Manual

Page 92

Black plate (93,1)

北米Model "A1920BE-B" EDITED: 2006/ 9/ 19

side of the power door locking switch,
close the driver

’s door once within 10

seconds after Step 4.
6. The turn signal lights flash 3 times to
indicate completion of the setting.

NOTE

If you do not close the driver

’s door

within 10 seconds after Step 4, a flash
of the turn signal lights will signal
timeout. If this happens, repeat the
whole procedure from Step 1.

You may have the above settings done by
your SUBARU dealer.

& Replacing the battery

When the transmitter battery begins to get
weak, transmitter range will begin to
decrease. Replace the battery as soon
as possible.

To replace the battery:

1. Open the transmitter case using a flat-
head screwdriver.

2. Remove the old battery from the
holder.

Negative (

−) side facing up

3. Replace with a new battery (Type
CR2025 or equivalent) making sure to
install the new battery with the negative
(

−) side facing up.

4. Reinstall the back half of the transmit-
ter case by snapping it back on.

After the battery is replaced, the trans-
mitter must be synchronized with the
keyless entry system

’s control unit.

Press either the

“ ” or “ ” button six

times to synchronize the unit.

CAUTION

. Do not let dust, oil or water get on

or in the transmitter when repla-
cing battery.

Keys and doors

2-9

– CONTINUED –