Subaru 2007 Impreza WRX - Manual (Page 123)

Black plate (124,1)
北米Model "A1920BE-B" EDITED: 2006/ 9/ 19
3-14
Instruments and controls
Warning and indicator lights
Several of the warning and indicator lights
come on momentarily and then go out
when the ignition switch is initially turned
to the
“ON” position. This permits check-
ing the operation of the bulbs.
Apply the parking brake and turn the
ignition switch to the
“ON” position. The
following lights come on:
. Seatbelt warning light
. SRS airbag system warning light
. Front passenger’s frontal airbag ON
indicator light
. Front passenger’s frontal airbag OFF
indicator light
. CHECK ENGINE warning light/Mal-
function indicator lamp
. Charge warning light
. Oil pressure warning light
. AT OIL temperature warning light (AT
vehicles)
. ABS warning light
. Brake system warning light
. All-Wheel Drive warning light (AWD AT
vehicles)
. Cruise control indicator light
. Cruise control set indicator light
If any lights fail to come on, it indicates a
burned-out bulb or a malfunction of the
corresponding system.
Consult your authorized SUBARU dealer
for repair.
&
Seatbelt warning light
and chime
Your vehicle is equipped with a seatbelt
warning device at the driver
’s seat, as
required by current safety standards.
There is a seatbelt warning light in the
combination meter.
If the driver has not yet fastened the
seatbelt when the ignition switch is turned
to the
“ON” position, the seatbelt warning
light will flash for 6 seconds, to warn that
the seatbelt is unfastened. If the driver
’s
seatbelt is not fastened, a chime will also
sound simultaneously.
If the driver
’s seatbelt is still not fastened 6
seconds later, the warning light will remain
lit for 15 seconds. If the driver
’s seatbelt is
still not fastened even 15 seconds later
(21 seconds after turning ON the ignition
switch), the warning lights will alternate
between flashing and steady illumination
at 15-second intervals, and the chime will
sound while the warning light is flashing.
Alternate flashing and steady illumination
of the warning lights and sounding of the
chime will continue until the driver fastens
the seatbelt.
NOTE
. If the driver unfastens the seatbelt
after fastening, the seatbelt warning
device operates as follows according
to the vehicle speed.
. At speeds lower than approxi-
mately 9 mph (15 km/h)
The warning light will alternate
between flashing and steady illumi-
nation at 15-second intervals. The
chime will not sound.
. At speeds higher than approxi-
mately 9 mph (15 km/h)
The warning light will alternate
between flashing and steady illumi-
nation at 15-second intervals and
the chime will sound while the
warning light is flashing.
. It is possible to cancel the warning
operation that follows the 6-second
warning after turning ON the ignition
switch. When the ignition switch is
turned ON next time, however, the
complete sequence of the warning
operation resumes. For further details
about canceling the warning operation,
please contact your SUBARU dealer.
&
SRS airbag system
warning light
When the ignition switch is turned to the