Subaru 2007 Impreza WRX - Manual (Page 129)

Black plate (130,1)
北米Model "A1920BE-B" EDITED: 2006/ 9/ 19
3-20
Instruments and controls
& Selector lever position indi-
cator (AT vehicles)
This indicator shows the position of the
selector lever.
&
Turn signal indicator
lights
These lights show the operation of the turn
signal or lane change signal.
If the indicator lights do not blink or blink
rapidly, the turn signal bulb may be burned
out. Replace the bulb as soon as possible.
Refer to the
“Replacing bulbs” section in
chapter 11.
&
High beam indicator
light
This light shows that the headlights are in
the high beam mode.
This indicator light also comes on when
the headlight flasher is operated.
&
Cruise control indica-
tor light
The cruise control indicator light comes on
when the ignition switch is turned to the
“ON” position and goes out after approxi-
mately 3 seconds.
This light comes on when the
“CRUISE”
main switch is pressed.
If you move the cruise control lever or
press the main switch button while turning
the ignition switch
“ON”, the cruise control
function is deactivated and the “CRUISE”
indicator light flashes. To reactivate the
cruise control function, turn the ignition
switch back to the
“Acc” or “LOCK”
position, and then turn it again to the
“ON” position.
&
Cruise control set in-
dicator light
The cruise control set indicator light
comes on when the ignition switch is
turned to the
“ON” position and goes out
after approximately 3 seconds.
This light comes on when vehicle speed
has been set.
&
Driver ’s control center
differential auto indica-
tor light (WRX-STI)
This light functions while the ignition
switch is
“ON”. When on, it indicates that
the driver ’s control center differential is set
to AUTO mode. It goes off when the
driver
’s control center differential’s manual
mode switch is pressed. For details, refer
to Chapter 7,
“Driver’s Control Center
Differential (DCCD) (WRX-STI) ”.