Subaru 2008 Forester 2.5X - Manual (Page 98)

Black plate (99,1)
北米Model "A8130BE-B" EDITED: 2007/ 7/ 25
5. While still holding down the “UNLOCK”
side of the power door locking switch,
close the driver
’s door once within 10
seconds after Step 4.
6. The turn signal lights flashes 3 times to
indicate completion of the setting.
NOTE
If you do not close the driver ’s door
within 10 seconds after Step 4, a flash
of the turn signal lights will signal time-
out. If this happens, repeat the whole
procedure from Step 1.
You may have the above settings done by
your SUBARU dealer.
& Replacing the battery
CAUTION
. Do not let dust, oil or water get on
or in the transmitter when repla-
cing the battery.
. Be careful not to damage the
printed circuit board in the trans-
mitter when replacing the battery.
When the transmitter battery begins to get
weak, transmitter range will begin to
decrease. Replace the battery as soon
as possible.
To replace the battery:
1. Open the transmitter case using a flat-
head screwdriver.
2. Separate the case.
3. Remove the old battery from the
holder.
1) Negative ( −) side facing up
4. Replace with a new battery (Type
CR2025 or equivalent) making sure to
install the new battery with the negative
(
−) side facing up.
5. Reinstall the back half of the transmit-
ter case by snapping it back on.
After the battery is replaced, the trans-
mitter must be synchronized with the
keyless entry system
’s control unit.
Press either the “ ” or “ ” button 6
times to synchronize the unit.
& Replacing lost transmitters
If you lose a transmitter or want to
purchase additional transmitters (up to
four can be programmed), you should re-
program all of your transmitters for secur-
Keys and doors
2-9
– CONTINUED –
2